EDAC Electronics Ltd. EDAC700 RTU Technical Reference Manual page 42

This sets the security number (PIN) used to access the Roster Menu over a phone call,
i.e. menu option '2' on the Spoken Menu.
This sets the security number (PIN) used to establish a remote modem connection. This
function is used to talk to an external device attached to the RS232 port of the EDAC700
RTU.
Example: Remote command; "ATDT <PHNUMBER> , , , , , , 4, , 0004"
Modems do not all wait the same time for a ','. The user may have to experiment to
achieve the desired result.
This sets the security number (PIN) used to establish a remote modem connection in
Program Mode. This allows the user to remotely setup the EDAC700 RTU as if it was
connected directly to the local RS232 port.
Example: Remote command; "ATDT <PHNUMBER>, , , , , , , 5, , 0005"
This sets the sequence of alarm notification calls made when multiple Groups have
triggered alarms.
No (default)
When set to "No" the EDAC700 RTU will make alarm notification calls alternatively from
each triggered Group.
Yes
When set to "Yes" the EDAC700 RTU will consider the lowest numbered group (Group
1) to have the highest priority. It will always dial the lowest triggered Group number, and
will keep dialling the same Group until acknowledged. It will then dial the next lowest
group.
Note!
When using "Group Priority = Yes", the EDAC700 RTU must be set up so that
Group 1 has the highest priority alarms wired into it, then Group 2, Group 3 etc.
Date: 31/10/12 Page 42File: 700b Technical Manual ver1.9.3.docm