Configure Call List (Call List Menu) - EDAC Electronics Ltd. EDAC700 RTU Technical Reference Manual

5.4

Configure Call List (Call List Menu)

The EDAC700 RTU must have a Call List defined before it can make alarm notification
calls. The Call List and Master Phone List only require one entry each in order to make
successful calls.
When building a Call List you must first select a phone number to call. If none are
defined the EDAC700 RTU will let you define them as required from within the "Call List
Menu".
Program Mode -> Configure Dialler -> Configure Call List
The "Call List" menu includes Add & Delete call list options.
As you define new Call Lists using Add a call list, they are added to the list in this menu.
You can modify any existing entry by pressing <Ok> when its number is displayed.
Select a phone number by scrolling through the numbers using <Up> & <Down>. The
dialler will give a double beep on the last number entry. You can also add a new
number from this option. Press <Up> from the first number listed to reach "Add phone
num".
This setting is a delay in minutes that the EDAC700 RTU will wait between calls from the
Call List. This is used to allow a user to phone in and cancel the alarm if required. It
also allows the EDAC700 RTU time to self-cancel if the alarm trigger has been removed
or gone back into its normal operating range.
This setting must be set if a pager is being called or text messaging to a cell phone are
being used.
New Zealand setup;
The "wait after call (m)" parameter shall not be set to the default value of 0.
When the EDAC700 RTU dials a number from the Call List it looks for an acknowledge
signal from the user. When set to "Yes" the EDAC700 RTU, after receiving the
Date: 31/10/12 Page 37File: 700b Technical Manual ver1.9.3.docm