EDAC Electronics Ltd. EDAC700 RTU Technical Reference Manual page 29

5.1.2 Analogue Settings
Program Mode -> Configure Dialler -> Configure I/O -> Add/Edit Input -> Input function -
> Analog/4-20
For more detail on these settings, refer to the Analogue Configuration section.
Enter the sensor low output value in mA.
Note! Will say "Low V value" if 0-1V or 0-10V has been selected.
Enter the sensor high output value in mA.
Enter the sensor low value in engineering units that the "Low mA value" represents
Enter the sensor high value in engineering units that the "High mA value" represents
Enter the calculated Offset in engineering units to calibrate the reading to the external
reference.
High alarm set point. Enter the signal level in engineering units that will cause a high
level alarm.
Date: 31/10/12 Page 29File: 700b Technical Manual ver1.9.3.docm