Vpn Passthrough - Planet WAP-500N User Manual

• Subnet Mask
• Default Gateway
• PPTP Server
• Username
• Password
• Connect on Demand
• Keep Alive
• Accept
• Cancel

4.4.3 VPN Passthrough

VPN Passthrough allows a secure virtual private network (VPN) connection between two sites. Enabling the
options on this page opens a VPN port and enables connections to pass through the AP without interruption.
Go to the "Operation Mode" page to configure the device as "WISP" and then go to "Router
Through" to enable VPN passthrough you required.
The page includes the following settings:
Object
• PPTP Passthrough
• L2TP Passthrough
• IPSec Passthrough
• Accept
Enter the device's WAN IP subnet mask provided by ISP.
Enter the device's WAN Gateway IP provided by ISP.
Enter the IP address of the PPTP server.
Enter the username provided by ISP.
Enter the password provided by ISP.
Select it to specify the maximum idle time. Internet connection will
disconnect when it reaches the maximum idle time, but it will
automatically connect when user tries to access the network.
Select whether to keep the Internet connection always on, or enter a
redial period once the internet loses connection.
Click Accept to apply the setting.
Click Cancel to cancel the setting.
Figure 4-20 VPN Passthrough
Description
Check this option to enable PPTP pass-through mode.
Check this option to enable L2TP pass-through mode.
Check this option to enable IPSec pass-through mode.
Click Accept to apply the setting.
-42-
User Manual of WAP-500N/WBS-500N
VPN Pass