Router (Wisp Mode Only); Dhcp Server Settings - Planet WAP-500N User Manual

Object
• Spanning Tree Status
• Bridge Hello Time
• Bridge Max Age
• Bridge Forward Delay
• Priority
• Accept
• Cancel

4.4 Router (WISP Mode Only)

(WISP Mode Only)

4.4.1 DHCP Server Settings

Go to the "Operation Mode" page to configure the device as
to configure the device's LAN IP settings. to configure the device's LAN IP settings.
On this page, enable the DHCP server to assign IP address to local wired/wireless clients after the device n this page, enable the DHCP server to assign IP address to local wired/wireless clients after the device is n this page, enable the DHCP server to assign IP address to local wired/wireless clients after the device
connected to the remote AP supplied by wireless ISP. connected to the remote AP supplied by wireless ISP.
Description Description
Click ON to enable or click OFF to disable the option. Click
Specify Bridge Hello Time in seconds. This value determines how often Specify Bridge Hello Time in seconds. This
the AP sends hello packets to communicate information about the the
t opology throughout the entire Bridged Local Area Network throughout the entire Bridged Local Area Network.
Specify Bridge Max Age in seconds. If another bridge in the spanning tree Spec
does not send a hello packet for a long period of time, it is assumed to be does not send a hello packet for a
dead. dead.
Specify Bridge Forward Delay in seconds. Forwarding delay time is the Specify Bridge Forward Delay in
time spent time spent in each of the Listening and Learning states before the
Forwarding state is entered. This delay is provided so that when a new Forwarding state is
bridge comes onto a busy network, it looks at some traffic before bridge comes onto a busy network, it looks at some traffic before
participating. participating.
Specify the Priority number. Smaller numbers have greater priority. Specify the Priority number. Smaller
Click Accept to apply the setting. Click
Click Cancel to cancel the setting. Click
page to configure the device as "WISP" and then go to "Router
Figure 4-14 DHCP Server Settings
User Manual of WAP
to disable the option.
packets to communicate information about the
long period of time, it is assumed to be
seconds. Forwarding delay time is the
Listening and Learning states before the
entered. This delay is provided so that when a new
numbers have greater priority.
-34-
WAP-500N/WBS-500N
value determines how often
bridge in the spanning tree
Router LAN Settings"