Dual Ethernet Lan Port - Emerson FLOBOSS S600 Instruction Manual

FloBoss S600 Instruction Manual

3.6 Dual Ethernet LAN Port

The optional P190 second Ethernet port on the FloBoss S600 is for high-speed communications using an
Ethernet Local Area Network (LAN) architecture. The speed of data transfer is 10M bps when using
10BaseT twisted pair cable.
NOTE: For information on the standard Ethernet port, refer to Section 3.3.3.
The P190 Dual Ethernet communications port is comprised of a mezzanine card and a port backplate with
a FCC-68 RJ-45 connector. Refer to Figure 3-5
The mezzanine card plugs into the PC/104 slot on the P152 CPU board. Connections to the port are made
at a communications module backplate which connects to the mezzanine card via an extension of the card.
This backplate will use the first I/O slot beside the P152 CPU slot.
The second Ethernet port is usually shipped already installed in the S600 unit from the factory. Field
installation is possible, when a specialized backplane and P152 CPU card are also installed. If installed at
the factory, no hardware configuration or wiring is required.
NOTE: Before using this port, verify the IP settings of the port on the front panel. From the
Startup menu, select Network Setup > Network I/F 2. If no addresses have been assigned, you will
need to assign them.
NOTE: Exercise CAUTION. Network I/F 1 and Network I/F 2 must have unique subnet masks.
Rev Sep/04
Figure 3-5. Dual Ethernet Communications Card
CPU 3-10