Section 7 - Startup; Starting The Floboss S600; Warm Start; Cold Start - Emerson FLOBOSS S600 Instruction Manual

FloBoss S600 Instruction Manual
This section describes the various procedures for starting and restarting the FloBoss S600 unit.
Section
7.1

Starting the FloBoss S600

7.2

Warm Start

7.3

Cold Start

7.4 Startup Menu
7.5 Network Setup
7.1 Starting the FloBoss S600
After the FloBoss S600 has been wired for power and connected to external devices, it may be activated by
energizing the external 24 volts dc power supply. When power is first applied, the FloBoss S600
automatically performs an initialization sequence, including a self-test routine. The unit displays the
message RESETTING. A warm start will automatically be performed.
7.2 Warm Start
A warm start does not affect the configuration memory (SRAM). The FloBoss S600 will continue
operation, using the data stored in the configuration memory just before the restart occurred. Any current
accumulated values and on-line changes that have not been saved will be preserved.
During a warm start, the FloBoss S600 displays the message RESTARTING.
Following a successful warm start, the Main menu displays. The Main menu is the starting point of the
display screens. For information on navigating the display screens, refer to Section 5.
If a valid configuration can not be found, the FloBoss S600 will not warm start. It will instead go to the
Startup menu. Please refer to Section 7.4 for details.
7.3 Cold Start
During a cold start, the configuration file is copied from Flash and replaces any on-line changes that have
been made to the configuration files since the last ones sent (downloaded) from a PC running Config 600
software or since the last backup. During a cold start, an option of keeping or resetting the cumulative
totals is also given. You can only keep totals if the structure of the database has not been changed.
Rev Sep/04
SECTION 7 – STARTUP
Startup
Page Number
7-1
7-1
7-1
7-3
7-3
7-1