Emerson FLOBOSS S600 Instruction Manual page 15

FloBoss S600 Instruction Manual
Disconnect the ribbon cable from the back of the front panel at the blue connector. Refer to
4.
Figure 2-4. Observe the orientation of the connector with its mating keyway. The ribbon cable
must be correctly re-inserted at the end of the installation process.
Do not remove the ribbon cable from the FloBoss S600 housing entrance. This might cause
damage to the unit.
Rev Sep/04
Figure 2-3. Lift Front Panel
Figure 2-4. Remove Connector
Installation
Disconnect
Here
2-4