Startup Menu; Network Setup - Emerson FLOBOSS S600 Instruction Manual

FloBoss S600 Instruction Manual
Once completed, the FloBoss S600 Main menu displays.

7.4 Startup Menu

If the FloBoss S600 has completed its start-up initialization sequence and has not automatically warm
started, the FloBoss S600 Startup menu displays. Refer to Figure 7-1.
NOTE: After modifying any data in the startup menu, a power cycle may be required.
The FloBoss S600 Startup menu options include:
♦ Warm Start – This selection restarts a previously configured FloBoss S600 where it left off prior
to being powered down.
♦ Cold Start – This is used to build a new metering database on the FloBoss S600 using the
configuration files stored in Flash memory.
♦ Network Setup – This is used to configure the TCP/IP, Gateway and Modbus addresses. For more
information, refer to Section 7.5.
♦ Reflash Firmware – This is used to reprogram the FloBoss S600 operating system firmware stored
in Flash memory. For more information, refer to Section 8.3.
♦ Factory Setup – This is used to perform Clear SRAM, and Format Flash procedures, as well as
other settings to be changed under instruction from the factory. For more information, refer to
Section 8.

7.5 Network Setup

The Network Setup option allows you to define the TCP/IP Ethernet, Gateway, and Modbus network
addresses.
Prior to any network communications, the necessary network settings should be set. These parameters can
only be viewed or changed via the Startup menu.
Rev Sep/04
1. WARM START
2. COLD START
3. NETWORK SETUP
4. REFLASH FIRMWARE
5.
6.
7.
8. FACTORY SETUP
Figure 7-1. Startup Menu
Startup 7-3