Assigning A Default Page; Assigning A Page To A Function Key; Using The Exponential Key - Emerson FLOBOSS S600 Instruction Manual

FloBoss S600 Instruction Manual
5.7.3 Security Code
Some operations at the front panel display will require the user to enter their security code. Use the
password that was assigned to you for access to the FloBoss S600.
Each user is allocated a security level between 0 (highest) and 9 (lowest). The security levels determine
which data you will be able to change. Level 0 is reserved and cannot be set as a login level for users.
The security level can be assigned or modified for each user from within CONFIG 600 software.

5.8 Assigning a Default Page

To define the default display using the Minus key:
Go to the required data display page.
1.
Press the Minus key.
2.
Press the Minus key again to confirm.
3.
To clear the default display, go to a menu page and repeat steps 2 and 3. To invoke the default display, use
the Clear key. Note that the Clear key will not work while in Edit mode.

5.9 Assigning a Page to a Function Key

To assign a data page to a Function key (F1, F2, F3, or F4):
Go to the required display page.
1.
Press the Decimal Point key.
2.
Press the desired F key (F1, F2, F3, or F4) to which the display page is to be assigned.
3.
Once programmed, an F key cannot be unassigned unless the SRAM is cleared or the FloBoss S600 is cold
started. However, you can re-assign a F key to a different display page.

5.10 Using the Exponential Key

The Expt key allows you to enter parameters in scientific notation.
The displayed value will be shown in scientific notation if it can not be displayed as a normal number. The
data value can be forced to always display in scientific notation from within Config 600 software. For
information, refer to the Config 600 User Manual or on-line help.
To enter an exponential value:
Key in the value.
1.
Press the Expt key (an E appears on the display) and then enter the required power.
2.
Press the Enter key.
3.
Rev Sep/04 Front Panel 5-8