Section 2 - Installation; Preparing For Installation - Emerson FLOBOSS S600 Instruction Manual

FloBoss S600 Instruction Manual
2
This section provides instructions on installing the FloBoss S600 unit, including installation preparation,
panel mounting procedures, and the installation and removal of the plug-in boards.
This section includes:
Section
2.1

Preparing for Installation

2.2 Environmental Considerations
2.3 Required Tools for Installation
2.4 Installing the FloBoss S600
2.5 Installation and Removal of the Boards
2.1 Preparing for Installation
Installation of the FloBoss S600 must conform to all applicable local codes and regulations. All
installation procedures should be in accordance with normal practices of good workmanship. Although the
FloBoss S600 shipped to you may not include all of the hardware options described in this manual, the
procedure for the basic installation of the unit remains the same.
It is strongly recommended that you familiarize yourself with the procedures described in
Note:
this section before you begin to install the FloBoss S600.
The FloBoss S600 uses a modular design that provides maximum flexibility and ease of installation. The
basic panel-mounted version consists of three major components:
♦ Fabricated metal case, complete with pre-installed PSU/backplate and four card slots for the plug-in
cards (comprising a dedicated CPU slot and three I/O slots).
♦ Removable front panel comprising the LCD display and keypad assembly.
♦ Plug-in boards, one CPU board and one I/O board are supplied for a basic configuration (two
blanking plates are supplied to cover the unused slots).
Figure 2-1 shows the FloBoss S600 system components with the appropriate user-provided tools.
Rev Sep/04
SECTION 2 – INSTALLATION
Installation
Page Number
2-1
2-2
2-2
2-3
2-7
2-1