Emerson FLOBOSS S600 Instruction Manual page 20

FloBoss S600 Instruction Manual
To install the plug-in boards:
1. Install the plug-in boards with care by aligning them in the guides (located at top and bottom of
the case). Gently slide the board until it mates fully with the appropriate connector on the
backplane.
2. Each plug-in board has two "pull tabs" on the backplate. These should be pressed securely in
place upon insertion.
The insertion and location of the plug-in boards along the guides does not require excessive
force. Take care not to twist or otherwise distort the boards during installation.
Secure the board in the case with the retention screws (two per board).
3.
Rev Sep/04
Figure 2-10. Board Ready for Removal or Final Insertion
Installation 2-9