Emerson FB2200 Flow Computer Instruction Manual
D301784X012
March 2019
Connecting to Ethernet
The Ethernet port is a standard 8-pin 10/100 Base T RJ-45 modular connector located on the
bottom right side of the CPU enclosure.
Figure 2-48. Connecting to Ethernet
1
Connect to an Ethernet switch using the appropriate Category 5 shielded patch cable.
Notes
The default Ethernet IP address is 192.168.1.10; the default port is 20000.
If you ordered Ethernet, the unit ships with Ethernet enabled. If you need to operate the device in
lower power mode, you must disable Ethernet. Jumper J10 on the CPU module (see
determines whether Ethernet is enabled or disabled. Refer to the
Replacement Guide (D301803X012)
CPU module.
60
Ethernet Port
for information on how to open the unit to gain access to the
Figure
2-49)
CPU Enclosure and Electronics Field
Installation