Braking system
•
Undo the two screws indicated and re-
move the brake calliper.
NOTE
SHOULD IT BE NECESSARY TO REPLACE
THE CALLIPER, FIRST LOOSEN THE FITTING
CONNECTING THE PIPE TO THE BRAKE CAL-
LIPER.
Refitting
•
To fit, follow the removal steps but in reverse order, and tighten the locking screws to the
prescribed torque using the recommended product.
Recommended products
Loctite 243 Medium strength threadlock
-
Locking torques (N*m)
Front brake calliper fixing screw 25
•
If the calliper is disconnected from the brake pipe:
CAUTION
ALWAYS USE NEW SEAL GASKETS FOR THE BRAKE PIPE UNION.
CAUTION
ONCE REFITTING IS FINISHED, BLEED THE SYSTEM.
Locking torques (N*m)
Brake fluid pipe-calliper fitting 20 ÷ 25
Front brake pads
Removal
CAUTION
THE OPERATIONS REFER TO ONLY ONE BRAKE CALLIPER, BUT APPLY TO BOTH CALLIP-
ERS.
BRAK SYS - 284
SCARABEO 500