APRILIA SCARABEO 500 2008 Service Station Manual page 142

Engine
020359Y 42 x 47 mm adaptor
020412Y 15-mm guide
- Place the safety Seeger ring locking the driven
pulley shaft bearing.
NOTE
PLACE IT IN THE POSITION SHOWN IN THE
FIGURE.
- Fit the pulley shaft oil seal on the transmission
side.
Refitting the hub cover bearings
- Heat the bearing seats on the cover using the air
heater.
- Support the hub cover using the stud bolt set.
Specific tooling
020151Y Air heater
020150Y Air heater support
- Fit the intermediate shaft bearing on the cover
using the specific tool.
NOTE
PLACE IT WITH THE BALLS FACING THE HUB
SIDE (THIS APPLIES TO BEARINGS WITH
PLASTIC CAGE).
Specific tooling
020376Y Adaptor handle
020360Y 52 x 55 mm adaptor
ENG - 142
SCARABEO 500