APRILIA SCARABEO 500 2008 Service Station Manual page 143

SCARABEO 500
020363Y 20-mm Oil seal guide
- Heat the wheel axle bearing seat from the cover
external side.
- Fit the wheel axle bearing on the cover until it
stops using the specific punch.
Specific tooling
020376Y Adaptor handle
020360Y 52 x 55 mm adaptor
020483Y 30-mm guide
- Refit the circlip.
- Support the hub cover using the stud bolt set.
- Fit the wheel axle oil seal with the sealing lip fac-
ing the inside of the cover.
- Place the oil seal flush with the crankcase.
Specific tooling
020376Y Adaptor handle
020360Y 52 x 55 mm adaptor
020476Y Stud bolt set
Refitting the hub bearings
- Place the 3 shafts as shown in the figure.
Engine
ENG - 143