Message Scratchpad - GE 469 Instruction Manual

5.2.6

Message Scratchpad

MESSAGE
5–14
programmable messages can be created and displayed (message scratchpad). For
example, the relay can alternately scan a motor identification message, the current in
each phase, and the hottest stator RTD. Default messages are shown in this subgroup.
Use the following procedure to add default messages:
1. Enter the correct passcode for the
settings (unless the passcode has already been entered or the passcode
ACCESS
is "0", defeating the passcode security feature).
2. Move to the message to be added to the default message list using the
and MESSAGE
MESSAGE
value or Message Scratchpad message.
3. Press ENTER. The message
be displayed for 5 seconds.
4. Press ENTER again while displayed to add the current message to the default
message list.
5. If the procedure was followed correctly, the
flash message will be displayed:
ADDED
6. To verify that the message was added, view the last message in the
DEFAULT MESSAGES
Use the following procedure to remove default messages:
1. Enter the correct passcode for the
settings (unless the passcode has already been entered or unless the
ACCESS
passcode is "0", defeating the passcode security feature).
2. Select the message to remove under the
group.
3. When the default message to be removed is shown, press ENTER. The relay dis-
plays the
PRESS [ENTER] TO REMOVE DEFAULT MESSAGE
4. Press ENTER to remove the current message from the default message list.
5. If the procedure was followed correctly, the following flash message will be dis-
played:
PATH: SETTINGS S1 469 SETUP
[
MESSAGE
MESSAGE
MESSAGE
MESSAGE
S1 469 SETUP
keys. The selected message can be any actual
PRESS [ENTER] TO ADD DEFAULT MESSAGES
subgroup.
S1 469 SETUP
S1 469 SETUP
DEFAULT MESSAGE
HAS BEEN REMOVED
MESSAGE SCRACTHPAD
TEXT 1
TEXT 2
TEXT 3
TEXT 4
GE MULTILIN
469 MOTOR RELAY
469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL
CHAPTER 5: SETTINGS
PASSCODE ENTER PASSCODE FOR
DEFAULT MESSAGE HAS BEEN
S1 469 SETUP
PASSCODE ENTER PASSCODE FOR
DEFAULT MESSAGES
message.
Range: 40 alphanumeric characters
Range: 40 alphanumeric characters
Range: 40 alphanumeric characters
Range: 40 alphanumeric characters
Range: 40 alphanumeric characters
will
sub-