GE 469 Instruction Manual page 290

6–40
• INVALID PASSCODE ENTERED: If an invalid passcode is entered for passcode security
feature, this message will flash on the display.
• INVALID SERVICE CODE ENTERED: This message appears if an invalid code is entered
in
S13 469 TESTING
• KEY PRESSED HERE IS INVALID: Under certain situations, certain keys have no
function (e.g. any number key while viewing Actual Values). If a key is pressed where it
should have no function, this message will appear.
• NEW PASSCODE HAS BEEN ACCEPTED: This message will appear as an acknowledge
that the new passcode has been accepted when changing the passcode for the
passcode security feature.
• NEW settings HAS BEEN STORED: This message appear each time a settings has
been altered and stored as shown on the display.
• NO ALARMS: This message appears if an attempt is made to enter the
subgroup when there are no active alarms.
ALARM STATUS
• NO START BLOCKS ACTIVE: This message appears if an attempt is made to enter the
A1 STATUS START BLOCKS
• NO TRIPS OR ALARMS TO RESET: If
present, this message will appear.
• OUT OF RANGE! ENTER: #### - ##### by #: If an entered settings value that is
outside of the acceptable range of values, the 469 displays this message, substituting
the proper values for that settings. An appropriate value may then be entered.
• PRESS [ENTER] TO ADD DEFAULT MESSAGE: If the
the 469 actual value messages, this message prompts the user to press
to add a new default message. To add a new default message,
pressed while this message is being displayed.
• PRESS [ENTER] TO REMOVE MESSAGE: If the decimal key is pressed in the
DEFAULT MESSAGES
message prompts the user to press
default message,
ENTER
• RESET PERFORMED SUCCESSFULLY: If all trip and alarm features that are active can
be cleared (i.e. the conditions that caused these trips and/or alarms are no longer
present), then this message will appear when a reset is performed, indicating that all
trips and alarms have been cleared.
• ROUNDED settings HAS BEEN STORED: A settings value entered with the numeric
keypad may be between valid settings values. The 469 detects this condition and
stores a value that has been rounded to the nearest valid settings value. To find the
valid range and step for a given settings, simply press
displayed.
• settings ACCESS IS NOW PERMITTED: This flash message notifies the user that
settings may now be altered and stored any time the passcode security feature is
enabled and a valid passcode is entered.
• settings ACCESS IS NOW RESTRICTED: This message appears if the passcode security
feature is enabled, a valid passcode has been entered, and the
.
GE MULTILIN USE ONLY
subgroup when there are no active Start Blocks.
is pressed when there are no trips or alarms
RESET
settings group, immediately followed by the
to remove a default message. To remove the
enter
must be pressed while this message is being displayed.
469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL
CHAPTER 6: ACTUAL VALUES
A1 STATUS
key is pressed anywhere in
ENTER
ENTER
must be
ENTER
S1 469 SETUP
key, this
ENTER
while the settings is being
HELP
S1 469 SETUP
again