GE 469 Instruction Manual page 122

4–32
From the main window menu bar, select the File > Properties menu
item and note the version code of the Settings file.
If this version (e.g. 4.0X shown below) is different than the Software
Revision code noted in step 2, select a New File Version that matches
the Software Revision code from the pull-down menu.
For example, if the software revision is 2.80 and the current Settings file revision is
4.00, change the Settings file revision to "4.0X", as shown below:
Enter any special comments
about the setpoint file here.
When complete, click Convert to convert the Settings file to the desired
revision.
A dialog box will request confirmation. See Loading Settings from a
File on page 4–33 for instructions on loading this Settings file into the
469.
Printing Settings and Actual Values
The EnerVista 469 Setup software allows the user to print partial or complete lists of
settings and actual values. Use the following procedure to print a list of settings:
Select a previously saved Settings file in the File pane or establish
communications with a 469 device.
From the main window, select the File > Print Settings menu item.
The Print/Export Options dialog box will appear.
Select Settings in the upper section and select either Include All
Features (for a complete list) or Include Only Enabled Features (for a
list of only those features which are currently used) in the filtering
section.
Select the desired setpoint version
from this menu. The 4.0x indicates
versions 4.00, 4.01, 4.02, etc.
469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL
CHAPTER 4: INTERFACES