Configuring the line rate
To do...
1.
Enter system view.
2.
Enter interface view.
3.
Configure the line rate for the interface.
Configuring packet resequencing
When the network traffic is out of sequence, some systems that cannot resequence packets, such as a video
conferencing terminal, may encounter mosaics. The packet resequencing function can alleviate the problem.
To do...
1.
Enter system view.
2.
Enter interface view.
3.
Enable packet
resequencing.
Displaying and maintaining traffic policing, GTS,
and line rate
To do...
Display CAR list information.
Display CAR information on the
specified interface.
Display interface GTS
configuration information.
Display interface line rate
configuration information.
Command...
system-view
interface interface-type interface-number
qos lr outbound cir committed-information-
rate [ cbs committed-burst-size [ ebs excess-
burst-size ] ]
Command...
system-view
interface interface-type
interface-number
qos resequencing
Command...
display qos carl [ carl-index ] [ | { begin | exclude |
include } regular-expression ]
display qos car interface [ interface-type interface-
number ] [ | { begin | exclude | include } regular-
expression ]
display qos gts interface [ interface-type interface-
number ] [ | { begin | exclude | include } regular-
expression ]
display qos lr interface [ interface-type interface-
number ] [ | { begin | exclude | include } regular-
expression ]
40
Remarks
—
—
Required.
After enabling or disabling packet resequencing on an
interface, you must re-enable the interface by using
shutdown and then undo shutdown to make your
configuration take effect on the interface.
Remarks
—
—
Required.
Remarks
Available in
any view.
Available in
any view.
Available in
any view.
Available in
any view.