Wan Connection; Wwan Antenna Connection (Cell Connector); Wireless Lan Antenna Connection (Wi-Fi Connectors) - Teldat Connect 104KF TLDPM00A1 Installation Manual

3 Components and Power Supply
Note
Only the LAN 1 connector is available during booting and in BIOS mode.

3.7.2 WAN Connection

The Teldat Connect-104KF router incorporates an Ethernet WAN 10/100/1000 BaseT port with automatic MDI/
MDIX.
The WAN port is independent of the Switch and is operated just like any other interface.
Please pay careful attention to the labeling to avoid confusing the switch with other port types:
Fig. 9: WAN PORT
Note
The WAN connector is not operational during booting and in BIOS mode.

3.7.3 WWAN Antenna Connection (Cell connector)

The Teldat Connect-104KF router has two unused 3G antenna connectors on the side panel.

3.7.4 Wireless LAN Antenna Connection (Wi-Fi connectors)

The Teldat Connect-104KF router has three RF antenna connectors for connecting an external antenna to improve
the quality of the signal received and transmitted by the Wireless LAN module.
This module is internal and can be activated by purchasing the appropriate software license. To assemble the anten-
nas supplied with the device, screw them into the connectors labeled Wi-Fi located on the rear panel and both side
panels of the router. Unscrew the antennas to disassemble them.
Fig. 10: Wi-Fi 1 Antenna
10
Teldat S.A.
Teldat Router Connect-104KF