Hp Dual Microsd To Usb Adapter Option; Memory Options - HP ProLiant ML110 Gen9 User Manual

HP dual microSD to USB adapter option

To install the component:
Power down the server (on page 18).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Place the server on its side.
3.
Remove the access panel (on page 18).
4.
If installed, remove the PCI air baffle (on page 22).
5.
Remove the system air baffle (on page 23).
6.
If installed, remove the HP Smart Storage Battery.
7.
Install the device adapter on the system board.
8.
Install the HP Smart Storage Battery on the server.
9.
Install the system air baffle (on page 24).
10.
If removed, install the PCI air baffle
11.
Install the access panel (on page 19).
12.
Return the server to an upright position.
13.
Connect each power cord to the server.
14.
Connect each power cord to the power source.
15.
Power up the server (on page 18).
16.

Memory options

IMPORTANT:
combination of these DIMMs can cause the server to halt during BIOS initialization.
("Install the PCI air
This server does not support mixing LRDIMMs or RDIMMs. Attempting to mix any
baffle" on page 22).
Hardware options installation 63