Table of Contents
Advertisement
10 Error messages
„Err2":
„Err3":
„Err4":
„Err5":
„Err7":
„Err8":
„NULL":
„FULL2":
„LH":
„Lo":
"5-Full": The display range of the Add Function is insufficient for the display of the
11 Service, maintenance, disposal
11.1 Cleaning
Before cleaning, please disconnect the appliance from the operating voltage.
Please do not use aggressive cleaning agents (solvents or similar agents), but a cloth
dampened with mild soap suds. Ensure that no liquid penetrates into the device and
wipe with a dry soft cloth.
Loose residue sample/powder can be removed carefully with a brush or manual
vacuum cleaner.
Spilled weighing goods must be removed immediately.
11.2 Service, maintenance
The appliance may only be opened by trained service technicians who are authorized
by KERN.
Before opening, disconnect from power supply.
11.3 Disposal
Disposal of packaging and appliance must be carried out by operator according to
valid national or regional law of the location where the appliance is used.
46
Value outside zero range
Value outside taring range
Calibration weight outside allowable range (+-1% for
calibration weight)
Piece weight smaller than readability
Disconnection time was too short (should be more than
3 seconds)
Impossible to carry out taring / resetting
Underload
Weighing range exceeded
Initial weight error Weight of weighing plate outside
allowable tolerance of 10%
Display unit waiting for weight on weighing tray
but none detected
sum total.
KLB-TM-BA-e-0811
Advertisement
Table of Contents
