Communication Protocol / Remote Control Commands; Response Messages From Balance - KERN KLB-TM Operating Manual

9.8 Communication protocol / remote control commands

Table 1: Instruction list for RS232 interface
Instruction: Meaning of Instruction:
Z
Set weight display at zero
T
Taring
S
Send stable weighing value in standard weighing unit
SI
Send weighing value immediately in standard weighing unit
SU
Send stable weighing value in current weighing value
SUI
Send weighing value immediately in current weighing unit
C1
Turn on continuous transmission in standard weighing unit
C0
Turn off continuous transmission in standard weighing unit
CU1
Turn on continuous transmission in current weighing unit
CO1
Turn off continuous transmission in current weighing unit
PC
Send all implemented instructions
Complete each instruction with CR LF.

9.8.1 Response messages from balance

Response message of balance after instruction was sent:
XX_
XX_A CR LF
XX_D CR LF
XX_ I CR LF
XX_^ CR LF
XX_v CR LF
XX_E CR LF
KLB-TM-BA-e-0811
Instruction:
Instruction accepted; will be executed
Instruction complete (appears after XX_A only)
Instruction received; impossible to carry out
Instruction received but time overflow error occurred
Instruction received, but insufficient load
Error during execution, timeout for stable weighing value
exceeded
43