Cisco Mds 9000 Family Nx-Os Fundamentals Configuration Guide - Cisco MDS 9000 Series Configuration Manual

Using the Cisco NX-OS Setup Utility
Step 13
Enter the SSH key type.
Type the SSH key you would like to generate (dsa/rsa)? rsa
Step 14 Enter the number of key bits within the specified range.
Enter the number of key bits? (768 to 2048): 2048
Step 15 Enter no (no is the default) to configure the NTP server.
Configure NTP server? (yes/no) [n]: no
Step 16 Enter shut (shut is the default) to configure the default switch port interface to the shut (disabled) state.
Configure default switchport interface state (shut/noshut) [shut]: shut
The management Ethernet interface is not shut down at this point. Only the Fibre Channel, iSCSI, FCIP, and
Note
Gigabit Ethernet interfaces are shut down.
Step 17 Enter auto (off is the default) to configure the switch port trunk mode.
Configure default switchport trunk mode (on/off/auto) [off]: auto
Step 18 Enter yes (yes is the default) to configure the switchport mode F.
Configure default switchport mode F (yes/no) [n]: y
Step 19 Enter off (off is the default) to configure the PortChannel auto-create state.
Configure default port-channel auto-create state (on/off) [off]: off
Step 20 Enter deny (deny is the default) to deny a default zone policy configuration.
Configure default zone policy (permit/deny) [deny]: deny
Denies traffic flow to all members of the default zone.
If you are executing the setup script after issuing a write erase command, you must explicitly change the default
Note
zone policy to permit for VSAN 1 after finishing the script using the following commands:
switch# configure terminal
switch(config)# zone default-zone permit vsan 1
Step 21 Enter no (no is the default) to disable a full zone set distribution.
Enable full zoneset distribution (yes/no) [n]: no
Disables the switch-wide default for the full zone set distribution feature.
You see the new configuration. Review and edit the configuration that you have just entered.
OL-29291-02

Cisco MDS 9000 Family NX-OS Fundamentals Configuration Guide

Configuring In-Band Management
23