Cisco Mds 9000 Family Nx-Os Fundamentals Configuration Guide - Cisco MDS 9000 Series Configuration Manual

Configuring In-Band Management
a) Enter the default gateway IP address.
IP address of the default gateway: default_gateway
Step 10 Enter yes (no is the default) to configure advanced IP options such as in-band management, static routes, default network,
DNS, and domain name.
Configure Advanced IP options (yes/no)? [n]: yes
a) Enter yes (no is the default) at the in-band management configuration prompt.
Continue with in-band (VSAN1) management configuration? (yes/no) [no]: yes
Enter the VSAN 1 IPv4 address.
VSAN1 IPv4 address: ip_address
Enter the IPv4 subnet mask.
VSAN1 IPv4 net mask: subnet_mask
b) Enter no (yes is the default) to enable IPv4 routing capabilities.
Enable ip routing capabilities? (yes/no) [y]: no
c) Enter no (yes is the default) to configure a static route.
Configure static route: (yes/no) [y]: no
d) Enter no (yes is the default) to configure the default network
Configure the default-network: (yes/no) [y]: no
e) Enter no (yes is the default) to configure the DNS IPv4 address.
Configure the DNS IP address? (yes/no) [y]: no
f) Enter no (no is the default) to skip the default domain name configuration.
Configure the default domain name? (yes/no) [n]: no
Step 11 Enter no (no is the default) to disable the Telnet service.
Enable the telnet service? (yes/no) [y]: no
Step 12 Enter yes (yes is the default) to enable the SSH service.
Enabled SSH service? (yes/no) [n]: yes

Cisco MDS 9000 Family NX-OS Fundamentals Configuration Guide

22
Using the Cisco NX-OS Setup Utility
OL-29291-02