Checking The State Of A Module - Cisco MDS 9000 Series Configuration Manual

Checking the State of a Module

2
5
6
8
9
Mod
---
2
5
6
8
9
* this terminal session
The Status column in the output should display an ok status for switching modules and an active or standby
(or HA-standby) status for supervisor modules. If the status is either ok or active, you can continue with your
configuration.
Note A standby supervisor module reflects the HA-standby status if the HA switchover mechanism is enabled.
If the warm switchover mechanism is enabled, the standby supervisor module reflects the standby status.
Checking the State of a Module
If your chassis has more than one switching module (also known as line card), you can check the progress by
issuing the show module command several times and viewing the Status column each time. The switching
module goes through a testing and an initializing stage before displaying an ok status.
This table describes the module states listed in the show module command output.
Cisco MDS 9000 Family NX-OS Fundamentals Configuration Guide
164
1.3(0.106a) 0.206 20:41:00:05:30:00:00:00 to 20:48:00:05:30:00:00:00
1.3(0.106a) 0.602 --
1.3(0.106a)) 0.602 -- <--------------- New running version in module 6
1.3(0.106a) 0.702 --
1.3(0.106a) 0.3 22:01:00:05:30:00:00:00 to 22:20:00:05:30:00:00:00
MAC-Address(es)
--------------------------------------
00-05-30-00-9d-d2 to 00-05-30-00-9d-de
00-05-30-00-64-be to 00-05-30-00-64-c2
00-d0-97-38-b3-f9 to 00-d0-97-38-b3-fd
00-05-30-01-37-7a to 00-05-30-01-37-fe
00-05-30-00-2d-e2 to 00-05-30-00-2d-e6
Serial-Num
----------
JAB064605a2
JAB06350B1R
JAB072705ja
JAB06280ae9
Managing Modules
OL-29291-02