Cisco Mds 9000 Family Nx-Os Fundamentals Configuration Guide - Cisco MDS 9000 Series Configuration Manual

Using the Cisco NX-OS Setup Utility
Enter the SSH key type.
Type the SSH key you would like to generate (dsa/rsa)? rsa
Enter the number of key bits within the specified range.
Enter the number of key bits? (768-2048) [1024]: 2048
Step 12
Enter yes (no is the default) to disable the Telnet service.
Enable the telnet service? (yes/no) [n]: yes
Step 13 Enter yes (yes is the default) to configure congestion or no_credit drop for FC interfaces.
Configure congestion or
Step 14 Enter con(con is the default) to configure congestion or no_credit drop.
Enter the type of drop to configure congestion/no_credit drop? (con/no) [c]:con
Step 15
Enter a value from 100 to 1000 (d is the default) to calculate the number of milliseconds for congestion or no_credit
drop.
Enter number of milliseconds for congestion/no_credit drop[100 - 1000] or [d/default] for default:100
Step 16 Enter a mode for congestion or no_credit drop.
Enter mode for congestion/no_credit drop[E/F]:
Step 17 Enter yes (no is the default) to configure the NTP server.
Configure NTP server? (yes/no) [n]: yes
Enter the NTP server IPv4 address.
NTP server IP address: ntp_server_IP_address
Step 18 Enter shut (shut is the default) to configure the default switch port interface to the shut (disabled) state.
Configure default switchport interface state (shut/noshut) [shut]: shut
The management Ethernet interface is not shut down at this point. Only the Fibre Channel, iSCSI, FCIP, and
Note
Gigabit Ethernet interfaces are shut down.
Step 19 Enter on (off is the default) to configure the switch port trunk mode.
Configure default switchport trunk mode (on/off/auto) [off]: on
Step 20 Enter yes (yes is the default) to configure the switchport mode F.
Configure default switchport mode F (yes/no) [n]: y
Step 21 Enter on (off is the default) to configure the PortChannel auto-create state.
Configure default port-channel auto-create state (on/off) [off]: on
OL-29291-02
no_credit drop for fc interfaces? (yes/no) [q/quit] to quit [y]:yes

Cisco MDS 9000 Family NX-OS Fundamentals Configuration Guide

Configuring Out-of-Band Management
17