Cisco Mds 9000 Family Nx-Os Fundamentals Configuration Guide - Cisco MDS 9000 Series Configuration Manual

Using the Cisco NX-OS Setup Utility
a) Enter yes (no is the default) to avoid configuring the read-only SNMP community string.
Configure read-only SNMP community string (yes/no) [n]: yes
b) Enter the SNMP community string.
SNMP community string: snmp_community
Step 7 Enter a name for the switch.
The switch name is limited to 32 alphanumeric characters. The default is switch.
Note
Enter the switch name: switch_name
Step 8
Enter yes (yes is the default) at the configuration prompt to configure out-of-band management.
Continue with Out-of-band (mgmt0) management configuration? [yes/no]: yes
a) Enter the mgmt0 IPv4 address.
Mgmt0 IPv4 address: ip_address
b) Enter the mgmt0 IPv4 subnet mask.
Mgmt0 IPv4 netmask: subnet_mask
Step 9 Enter yes (yes is the default) to configure the default gateway.
Configure the default-gateway: (yes/no) [y]: yes
a) Enter the default gateway IP address.
IP address of the default gateway: default_gateway
Step 10 Enter yes (no is the default) to configure advanced IP options such as in-band management, static routes, default network,
DNS, and domain name.
Configure Advanced IP options (yes/no)? [n]: yes
a) Enter no (no is the default) at the in-band management configuration prompt.
Continue with in-band (VSAN1) management configuration? (yes/no) [no]: no
b) Enter yes (yes is the default) to enable IPv4 routing capabilities.
Enable ip routing capabilities? (yes/no) [y]: yes
OL-29291-02

Cisco MDS 9000 Family NX-OS Fundamentals Configuration Guide

Configuring Out-of-Band Management
15