High Availability for CDP
High Availability for CDP
The Cisco NX-OS software supports stateless restarts for CDP. After a reboot or a supervisor module
switchover, the Cisco NX-OS software applies the running configuration. For more information on high
availability, see the .
Configuring CDP
This section describes how to configure CDP.
Enabling or Disabling CDP Globally
CDP is enabled by default. You can disable CDP and then reenable it.
CDP must be enabled on the device before you enable CDP on any interfaces. If CDP is disabled globally
and you enable CDP on specified interfaces, CDP will not be active on those interfaces. The system does not
return an error message when this occurs.
SUMMARY STEPS
1. configure terminal
2. cdp enable
3. (Optional) copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
cdp enable
Example:
switch(config)# cdp enable
Step 3
copy running-config startup-config
Example:
switch(config)# copy running-config
startup-config
Cisco MDS 9000 Family NX-OS Fundamentals Configuration Guide
126
Purpose
Enters configuration mode.
Enables the CDP feature on the entire device. This
is enabled by default .
(Optional)
Saves this configuration change.
Configuring CDP
OL-29291-02