Remote Operation; Turning Remote Operation On/Off; Remote Operations - Yaesu DR-1 Operating Manual

Remote Operations

Remote Operation

You can control the repeater operation remotely by connecting an external controller through the [CONTROL I/O] connector at the
back of the repeater (see page 16).
To use the repeater under remote control, set up the repeater after it is connected to the external controller.

Turning remote operation ON/OFF

When the remote operation is "ON", the repeater operates according to the control instructions received from the external controller
(the instructions are received through the pin 11 to pin 14 of the [CONTROL I/O] connector). When the remote operation is "OFF", the
repeater operates according to the settings determined through the setup mode.
1
Touch [SETUP]
The setup mode screen will appear.
2
Touch [F]
The setup menu will appear.
3
Touch [MODE/REMOTE]
The menu list will appear.
4
Select and touch [REMOTE]
The set value will change between [OFF] and [ON] each time it is touched.
Tip Factory default: OFF
5
Touch [BACK] three times
The setting is determined and the display will return to the operation mode screen.
Note that [REMOTE] at the bottom left of the screen is displayed in red.
23