Show Mvr Interface - Edge-Core ECS4620-28T Quick Start Manual

Chapter 24
| Multicast Filtering Commands
MVR for IPv4

show mvr interface

This command shows MVR configuration settings for interfaces attached to the
MVR VLAN.
Syntax
show mvr [domain domain-id] interface
domain-id - An independent multicast domain. (Range: 1-5)
Default Setting
Displays configuration settings for all attached interfaces.
Command Mode
Privileged Exec
Example
The following displays information about the interfaces attached to the MVR VLAN
in domain 1:
Console#show mvr domain 1 interface
MVR Domain : 1
Flag: H - immediate leave by host ip
Port Type Status
-------- -------- ------------------- ---------
Eth 1/ 1 Source Active/Forwarding
Eth 1/ 2 Receiver Inactive/Discarding Disabled
Eth 1/ 3 Source Inactive/Discarding
Eth 1/ 1 Receiver Active/Forwarding
Eth 1/ 4 Receiver Active/Discarding
Console#
Table 135: show mvr interface - display description
Field
MVR Domain
Port
Type
Status
Immediate
Static Group Address
Immediate
Disabled
Disabled
Description
An independent multicast domain.
Shows interfaces attached to the MVR.
Shows the MVR port type.
Shows the MVR status and interface status. MVR status for source ports
is "ACTIVE" if MVR is globally enabled on the switch. MVR status for
receiver ports is "ACTIVE" only if there are subscribers receiving
multicast traffic from one of the MVR groups, or a multicast group has
been statically assigned to an interface. Also shows if MVR traffic is
being forwarded or discarded.
Shows if immediate leave is enabled or disabled.
Shows any static MVR group assigned to an interface, and the receiver
VLAN.
– 726 –
Static Group Address
-------------------------
234.5.6.8(VLAN2)
225.0.0.1(VLAN1)
225.0.0.9(VLAN3)