Edge-Core ECS4620-28T Quick Start Manual page 1601

clear ipv6 mld group
Command Usage
◆
MLDv1 is derived from IGMPv2, and MLDv2 from IGMPv3. IGMP uses IP Protocol
2 message types, and MLD uses IP Protocol 58 message types, which is a subset
of the ICMPv6 messages.
◆
MLDv2 adds the ability for a node to report interest in listening to packets with
a particular multicast address only from specific source addresses as required to
support Source-Specific Multicast (SSM), or from all sources except for specific
source addresses.
◆
MLDv2 supports Source-Specific Multicast (SSM) which builds a reverse tree
from a host requesting a service back up to the multicast server.
◆
Multicast hosts on the subnet may support either MLD versions 1 or 2.
Example
Console(config-if)#ipv6 mld version 1
Console(config-if)#
This command deletes entries from the MLD cache.
Syntax
clear ipv6 mld group [group-address | interface interface]
group-address - IPv6 address of the multicast group.
interface
vlan vlan-id - VLAN ID. (Range: 1-4094)
Default Setting
Deletes all entries in the cache if no options are selected.
Command Mode
Privileged Exec
Command Usage
Enter the address for a multicast group to delete all entries for the specified group.
Enter the interface option to delete all multicast groups for the specified interface.
Enter no options to clear all multicast groups from the cache.
Example
The following example clears all multicast group entries for VLAN 1.
Console#clear ipv6 mld interface vlan 1
Console#
Chapter 24
– 771 –
| Multicast Filtering Commands
MLD (Layer 3)