Igmp Proxy Routing - Edge-Core ECS4620-28T Quick Start Manual

IGMP Proxy Routing

ip igmp proxy
Query Interval
Query Max Response Time
Last Member Query Interval
Querier
Joined Groups :
Static Groups :
switch#
This section describes commands used to configure IGMP Proxy Routing on the
switch.
Table 152: IGMP Proxy Commands
Command
ip igmp proxy
ip igmp proxy unsolicited-
report-interval
show ip igmp interface
To enable IGMP proxy service, follow these steps:
1.
Use the ip multicast-routing
the router.
2.
Use the ip igmp proxy
interface that is attached to an upstream multicast router.
3.
Use the ip igmp command to enable IGMP on the downstream interfaces from
which to forward IGMP membership reports.
4.
Optional – Use the ip igmp proxy unsolicited-report-interval
indicate how often the system will send unsolicited reports to the upstream
router.
This command enables IGMP proxy service for multicast routing, forwarding IGMP
membership information monitored on downstream interfaces onto the upstream
interface in a summarized report. Use the no form to disable proxy service.
Syntax
[no] ip igmp proxy
Default Setting
Disabled
Chapter 24
: 125 sec
: 100 (resolution in 0.1 sec)
: 10 (resolution in 0.1 sec)
: 0.0.0.0
Function
Enables IGMP proxy service for multicast routing
Specifies how often the upstream interface should
transmit unsolicited IGMP reports
Displays multicast information for the specified interface
command to enable IP multicasting globally on
command to enable IGMP proxy on the upstream
– 763 –
| Multicast Filtering Commands
IGMP Proxy Routing
Mode
IC
IC
PE
command to