Show Ipv6 Mld Groups - Edge-Core ECS4620-28T Quick Start Manual

Chapter 24
| Multicast Filtering Commands
MLD (Layer 3)

show ipv6 mld groups

This command displays information on multicast groups active on the switch and
learned through MLD.
Syntax
show ipv6 mld groups [{group-address | interface} [detail] | detail]
group-address - IPv6 multicast group address. (Note that link-local scope
addresses FF02:* are not allowed.)
interface
vlan vlan-id - VLAN ID. (Range: 1-4094)
detail - Displays detailed information about the multicast process and
source addresses when available.
Command Mode
Privileged Exec
Command Usage
To display information about multicast groups, MLD must first be enabled on the
interface to which a group has been assigned using the
multicast routing must be enabled globally on the system using the
routing command.
Example
The following shows options for displaying MLD group information.
Console#show ipv6 mld groups
Group Address
--------------------------------------- --------------- -------- --------
Console#show ipv6 mld groups detail
Interface : VLAN 1
Group : FFEE::101
Uptime : 0h:2m:7s
Group Mode : Include
Last Reporter : FE80::0101
Group Source List:
Source Address
--------------------------------------- ----------- ----------- ---
Console#
II
Table 154: show ipv6 mld groups - display description
Field
Group Address
Interface VLAN
Uptime
Interface VLAN
FFEE::101
Uptime
FFEE::0101 0h:0m:12s
Description
IP multicast group address with subscribers directly attached or
downstream from the switch.
The interface on the switch that has received traffic directed to the
multicast group address.
The time elapsed since this entry was created.
– 772 –
ipv6 mld command, and
ip multicast-
Uptime Expire
1 0:1:59 Never
Expire Fwd
0h:0m:0s Yes