Power Safety; Power Cord Usage - Symantec NetBackup 5230 Maintenance Manual

Power safety

Power cord usage

See "Power cord usage"
The power supply in this product contains no user-serviceable parts. There may
be more than one supply in this product. Refer servicing to qualified personnel only.
Do not attempt to modify or use the supplied AC power cord if it is not the exact
type required. A product with more than one power supply always comes with a
separate AC power cord for each supply.
The power button, DOES NOT completely turn off the AC power. A 5V standby
power is still active whenever the system is plugged in. To remove AC power from
the appliance, you must unplug each AC power cord from the outlet or the power
supply.
The power cord(s) is considered the disconnect device to the main (AC) power.
The socket outlet that the appliance plugs into, should be installed near the
equipment and should be easily accessible.
If an AC power cord was not provided with the product, purchase two that are
approved for use in your country.
To avoid electrical shock or fire, check the power cords to be used with the product
and read the following information:
Never attempt to modify or use the AC power cord(s) if they are not the exact
■
type that is required for your location.
The power cord must have an electrical rating that is greater than the electrical
■
current rating marked on the product.
The power cord must have a safety ground pin or contact that is suitable for the
■
electrical outlet.
The power supply cord(s) is/are the main disconnect device to AC power. The
■
sockets or outlets must be near the equipment and readily accessible for
disconnection.
The power supply cords must be plugged into the sockets or the outlets that are
■
provided with a suitable earth ground.
See "Power cord criteria"
Detailed safety and maintenance information
on page 48.
on page 49.
48
Power safety