Table of Contents
Advertisement
SpectraLink 8000 Telephony Gateway Administration Guide
Connect SpectraLink 8000 Telephony Gateway to Demarc
Blocks
Connect SpectraLink 8000 Telephony Gateway to LAN
36
When installing a system with four or fewer SpectraLink 8000
Telephony Gateways and a SpectraLink 8000 SVP Server, no IPC
cables are required. For this configuration, follow the directions for
connecting five or more SpectraLink 8000 Telephony Gateways.
Connect five or more SpectraLink 8000 Telephony
Gateways
To mount five or more SpectraLink 8000 Telephony Gateways:
1. Mount the SpectraLink 8000 Telephony Gateways on the
backboard or rack.
2. No IPC cable connection is required for five or more SpectraLink
8000 Telephony Gateways. Simply connect each SpectraLink 8000
Telephony Gateway to the local area network via an Ethernet
Switch per Connect SpectraLink 8000 Telephony Gateway to LAN
below.
3. This system configuration requires a SpectraLink 8000 SVP Server.
See the document SpectraLink 8000 SVP Server Administration Guide
for SRP.
Connect the male RJ-21 connector from the appropriate demarcation
block to the designated RJ-21 connector (A or B) on each SpectraLink
8000 Telephony Gateway. Secure the cables using the keeper.
Each Gateway requires a separate Ethernet connection on an Ethernet
switch. Using an RJ-45 cable, connect the
SpectraLink 8000 Telephony Gateway to the connecting port on the
same Ethernet switch.
Connect power
1. Once the units have been properly grounded, connect the power
plug from the AC adapter to the jack labeled
SpectraLink 8000 Telephony Gateway.
NETWORK
port on each
on the
PWR
PN: 1725-36028-001_T.doc
Advertisement
Table of Contents
