Table of Contents
Advertisement
Polycom RMX 2000 Hardware Guide
Table 1-4
Polycom RMX 2000 Component Description
Component
CNTL (CPU)
Module
Power Supply
Drawer
Fan Drawer
Multi Processor
Module (MPM)
Card
Description
The CNTL module controls and manages the RMX 2000.
The CNTL module has an ComExpress Pentium-M
1.4GHz processor, a 40GB hard disk drive, 1GB Compact
Flash and 1GB of DDR RAM.
The Operating System is Linux.
The Power Supply drawer is located below the MPM/
MPM+ Cards and is connected to the backplane by
means of a power connector. It operates at 100-240 volts
AC 50/60 Hz, and provides +48VDC 700W output with
built-in load sharing capabilities.
Three fans are mounted sideways in a drawer. Airflow is
from right to left, and out the side of the MCU. The drawer
is connected to the Back-plane by a connector.
The MPM cards perform the various RTP, audio and video
processing functions on the RMX 2000. MPM cards are
based on the ATCA standard, with a card manager (CM)
and up to 26 720MHz TI DSP's.
Two types are available:
•
MPM - F - 26 DSP's
•
MPM - H - 13 DSP's
1-9
Advertisement
Table of Contents
