Unlocking The Drive And Release Latch - IBM 3500 Service Manual

BB01L
BB01L
mmvdisk: A lower priority value means a higher need for replacement.
b) Prepare each of the pdisk name entries for replacement with the following command:
mmvdisk pdisk replace –-prepare –-recovery-group <rg name> --pdisk <pdisk name>
To prepare pdisk e2s11 of recovery group BB01L for replacement, run the following command:
# mmvdisk pdisk replace --prepare --recovery-group BB01L --pdisk e2s11
mmvdisk: Suspending pdisk e2s11 of RG BB01L in location SX32901810-11.
mmvdisk: Location SX32901810-11 is Enclosure 2 Drive 11.
mmvdisk: Carrier released.
mmvdisk:
mmvdisk:
mmvdisk:
mmvdisk:
mmvdisk:
mmvdisk:
mmvdisk:
The drive that is associated with the pdisk name in the previous command must have the amber
LED ON to indicate it is safe to remove this drive.
3. Remove the drive, which has amber LED ON.
a) Press the blue touchpoint to unlock the latching handle, as shown in Figure 5 on page 4.

Unlocking the drive and release latch.

Figure 5. Unlocking the drive and release latch
b) Lift the handle and slide the drive out of the enclosure, as shown in the following figure.
Figure 6. Removing NVMe drive
4. Insert the FRU replacement drive into the slot.
4 IBM Elastic Storage System 3500: Service Guide
e2s11
e3s01
- Remove carrier.
- Replace disk in location SX32901810-11 with type '00W1240'.
- Reinsert carrier.
- Issue the following command:
mmvdisk pdisk replace --recovery-group BB01L --pdisk 'e2s11'
1.15 00W1240
1.15 00W1240
Enclosure 2 Drive 11
Enclosure 3 Drive 1