Configuring Hwtacacs Schemes - HP 5500 HI Series Configuration Manual

Task
Clear the buffered stop-accounting
requests for which no responses have
been receive.

Configuring HWTACACS schemes

NOTE:
You cannot remove the HWTACACS schemes in use or change the IP addresses of the HWTACACS
servers in use.
HWTACACS configuration task list
Task
Creating an HWTACACS scheme
Specifying the HWTACACS authentication servers
Specifying the HWTACACS authorization servers
Specifying the HWTACACS accounting servers and the relevant parameters
Specifying the shared keys for secure HWTACACS communication
Specifying the VPN to which the servers belong
Setting the username format and traffic statistics units
Specifying a source IP address for outgoing HWTACACS packets
Setting timers for controlling communication with HWTACACS servers
Displaying and maintaining HWTACACS
Creating an HWTACACS scheme
The HWTACACS protocol is configured on a per scheme basis. Before performing other HWTACACS
configurations, follow these steps to create an HWTACACS scheme and enter HWTACACS scheme
view:
Step
1. Enter system view.
2. Create an HWTACACS scheme
and enter HWTACACS scheme
view.
NOTE:
• Up to 16 HWTACACS schemes can be configured.
A scheme can be deleted only when it is not referenced.
•
Command
reset stop-accounting-buffer
{ radius-scheme radius-scheme-name |
session-id session-id | time-range
start-time stop-time | user-name
user-name } [ slot slot-number ]
Command
system-view
hwtacacs scheme
hwtacacs-scheme-name
34
Remarks
Available in user view
Remarks
Required
Required
Optional
Optional
Required
Optional
Optional
Optional
Optional
Optional
Remarks
N/A
Not defined by default.