Displaying And Maintaining Arp Detection; User Validity Check Configuration Example - HP 5500 HI Series Configuration Manual

To configure the ARP detection logging function:
Step
1. Enter system view.
2. Enable the ARP detection
logging function.

Displaying and maintaining ARP detection

Task
Display the VLANs enabled
with ARP detection.
Display the ARP detection
statistics.
Clear the ARP detection
statistics.

User validity check configuration example

Network requirements
As shown in
entries for connected hosts.
Figure 119 Network diagram
Configuration procedure
1. Add all ports on Switch B into VLAN 10, and configure the IP address of VLAN-interface 10 on
Switch A. (Details not shown.)
Command
system-view
arp detection log enable
Command
display arp detection [ | { begin | exclude |
include } regular-expression ]
display arp detection statistics [ interface
interface-type interface-number ] [ | { begin |
exclude | include } regular-expression ]
reset arp detection statistics [ interface
interface-type interface-number ]
Figure 1 19, configure Switch B to perform user validity check based on 802.1X security
380
Remarks
N/A
By default, the ARP detection
logging function is enabled.
This command is available only in
Release 5206 and later.
Remarks
Available in any view
Available in any view
Available in user view