Verifying The Configuration - HP 5500 HI Series Configuration Manual

[Sysname-luser-test] service-type terminal
[Sysname-luser-test] authorization-attribute level 3
[Sysname-luser-test] password
Password:***********
Confirm :***********
Updating user(s) information, please wait...........
[Sysname-luser-test] quit
# Save the configuration.
[Sysname] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
flash:/startup.cfg exists, overwrite? [Y/N]:y
Validating file. Please wait..........................
Saved the current configuration to mainboard device successfully.
Configuration is saved to device successfully.
[Sysname] quit
# Reboot the switch.
<Sysname> reboot
CAUTION:
If you do not create a local user and its password before you reboot the switch, you cannot log in to the
switch after the switch reboots. In this case, reboot the switch without the configuration file (by ignoring or
removing the configuration file) so that the switch operates in non-FIPS mode, and then make correct
configurations.

Verifying the configuration

After the switch reboots, enter the username (test) and password (AAbbcc1234%). The system prompts
that your first login is successful, and asks you to enter a new password. Enter a new password which has
at least four characters different than the previous one and confirm the password. Then, the system
displays the <Sysname> prompt.
User interface aux0 is available.
Please press ENTER.
Login authentication
Username:test
Password:
Info: First logged in. For security reasons you will need to change your password.
Please enter your new password.
Password:**********
Confirm :**********
Updating user(s) information, please wait...........
<Sysname>
# Display the current FIPS mode. You can see that the FIPS mode is enabled.
424