Sftp Server Configuration Example - HP 5500 HI Series Configuration Manual

Remote
Downloading file successfully ended
# Upload the local file pu to the server, save it as puk, and check if the file has been uploaded
successfully.
sftp-client> put pu puk
Local file:pu --->
Uploading file successfully ended
sftp-client> dir
-rwxrwxrwx
-rwxrwxrwx
-rwxrwxrwx
drwxrwxrwx
drwxrwxrwx
-rwxrwxrwx
-rwxrwxrwx
sftp-client>
# Terminate the connection to the remote SFTP server.
sftp-client> quit
Bye
Connection closed.
<SwitchA>

SFTP server configuration example

Unless otherwise noted, devices in the configuration example are operating in non-FIPS mode.
Network requirements
As shown in
SFTP client, needs to log in to the switch for file management and file transfer. Use password
authentication and configure the username client002 and the password aabbcc for the client on the
switch.
Figure 102 Network diagram
Configuration procedure
1. Configure the SFTP server:
# Generate the RSA key pairs.
<Switch> system-view
[Switch] public-key local create rsa
The range of public key size is (512 ~ 2048).
NOTES: If the key modulus is greater than 512,
It will take a few minutes.
Press CTRL+C to abort.
file:/pubkey2 --->
Remote file: /puk
1 noone nogroup
1 noone nogroup
1 noone nogroup
1 noone nogroup
1 noone nogroup
1 noone nogroup
1 noone nogroup
Figure 102, an SSH connection is required between the host and the switch. The host, an
Local file: public
1759 Aug 23 06:52 config.cfg
225 Aug 24 08:01 pubkey2
283 Aug 24 07:39 pubkey
0 Sep 01 06:22 new
0 Sep 02 06:33 new2
283 Sep 02 06:35 pub
283 Sep 02 06:36 puk
334