Fips Compliance; Configuration Task List; Configuring An Ssl Server Policy - HP 5500 HI Series Configuration Manual

Figure 107 SSL protocol stack
SSL record protocol—Fragments data to be transmitted, computes and adds MAC to the data, and
•
encrypts the data before transmitting it to the peer end.
• SSL handshake protocol—Negotiates the cipher suite to be used for secure communication
(including the symmetric encryption algorithm, key exchange algorithm, and MAC algorithm),
securely exchanges the key between the server and client, and implements identity authentication
of the server and client. Through the SSL handshake protocol, a session is established between a
client and the server. A session consists of a set of parameters, including the session ID, peer
certificate, cipher suite, and master secret.
SSL change cipher spec protocol—Used for notification between the client and the server that the
•
subsequent packets are to be protected and transmitted based on the newly negotiated cipher suite
and key.
SSL alert protocol—Enables the SSL client and server to send alert messages to each other. An alert
•
message contains the alert severity level and a description.

FIPS compliance

The device supports the FIPS mode that complies with NIST FIPS 140-2 requirements. Support for features,
commands, and parameters might differ in FIPS mode (see

Configuration task list

Task

Configuring an SSL server policy

Configuring an SSL client policy
Configuring an SSL server policy
An SSL server policy is a set of SSL parameters for a server to use when booting up. An SSL server policy
takes effect only after it is associated with an application such as HTTPS.
SSL mainly comes in these versions: SSL 2.0, SSL 3.0, and TLS 1.0, where TLS 1.0 corresponds to SSL 3.1.
When the switch acts as an SSL server, it can communicate with clients running SSL 3.0 or TLS 1.0, and
can identify the SSL 2.0 Client Hello message from a client supporting SSL 2.0 and SSL 3.0/TLS 1.0 and
notify the client to use SSL 3.0 or TLS 1.0 to communicate with the server.
To configure an SSL server policy:
"Configuring
Remarks
Required
Optional
343
FIPS") and non-FIPS mode.