Configuring Layer 2 Portal Authentication - HP 5500 HI Series Configuration Manual

Verifying the configuration
Execute the display portal interface command to check whether the portal configuration has taken effect.
After Host passes portal authentication, perform the display portal user command to view information
about online portal users on Switch A.
[SwitchA] display portal user all
Index:2
State:ONLINE
SubState:NONE
ACL:NONE
Work-mode:stand-alone
VPN instance:vpn1
MAC
----------------------------------------------------------------------------
000d-88f7-c268
Total 1 user(s) matched, 1 listed.

Configuring Layer 2 portal authentication

Network requirements
As shown in
authentication on users connected to port GigabitEthernet 1/0/1. More specifically,
Use the remote RADIUS server for authentication, authorization and accounting.
•
Use the remote DHCP server to assign IP addresses to users.
•
The listening IP address of the local portal server is 4.4.4.4. The local portal server pushes the
•
user-defined authentication pages to users and uses HTTPS to transmit authentication data.
Add users passing authentication to VLAN 3.
•
Add users failing authentication to VLAN 2, to allow the users to access resources on the update
•
server.
• The host obtains an IP address through DHCP. Before authentication, the DHCP server assigns an IP
address in segment 192.168.1.0/24 to the host. When the host passes the authentication, the DHCP
server assigns an IP address in segment 3.3.3.0/24 to the host. When the host fails authentication,
the DHCP server assigns an IP address in segment 2.2.2.0/24 to the host.
IP
3.3.0.1
Figure 69, a host is directly connected to a switch. The switch performs Layer 2 portal
Vlan Interface
3 Vlan-interface3
179