Configuration Procedure; Configuration Example - HP 5500 HI Series Configuration Manual

If ARP gateway protection works with ARP detection, and ARP snooping, ARP gateway protection
•
applies first.

Configuration procedure

To configure ARP gateway protection:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet interface
view/Layer 2 aggregate interface view.
3. Enable ARP gateway protection for a
specific gateway.

Configuration example

Network requirements
As shown in
Switch B intends to send to Switch A is sent to Host B.
Configure Switch B to block such attacks.
Figure 122 Network diagram
Configuration procedure
# Configure ARP gateway protection on Switch B.
<SwitchB> system-view
[SwitchB] interface gigabitethernet 1/0/1
[SwitchB-GigabitEthernet1/0/1] arp filter source 10.1.1.1
[SwitchB-GigabitEthernet1/0/1] quit
[SwitchB] interface gigabitethernet 1/0/2
[SwitchB-GigabitEthernet1/0/2] arp filter source 10.1.1.1
Figure 122, Host B launches gateway spoofing attacks to Switch B. As a result, traffic that
Command
system-view
interface interface-type
interface-number
arp filter source ip-address
386
Remarks
N/A
N/A
Disabled by default