Configuring Hwtacacs Schemes - HP FlexNetwork 10500 Series Security Configuration Manual

•
RADIUS server unreachable notification—The RADIUS server cannot be reached. RADIUS
generates this notification if it does not receive a response to an accounting or authentication
request within the specified number of RADIUS request transmission attempts.
•
RADIUS server reachable notification—The RADIUS server can be reached. RADIUS
generates this notification for a previously blocked RADIUS server after the quiet timer expires.
•
Excessive authentication failures notification—The number of authentication failures
compared to the total number of authentication attempts exceeds the specified threshold.
You can configure SNMP parameters to control the output of these SNMP notifications. For more
information, see Network Management and Monitoring Configuration Guide.
To enable SNMP notifications for RADIUS:
Step
1. Enter system view.
2. Enable SNMP notifications
for RADIUS.
Displaying and maintaining RADIUS
Execute display commands in any view and reset commands in user view.
Task
Display the RADIUS scheme
configuration.
Display RADIUS packet statistics.
Clear RADIUS statistics.

Configuring HWTACACS schemes

Configuration task list
Tasks at a glance
(Required.)
(Required.)
(Optional.) Specifying the HWTACACS authorization servers
(Optional.) Specifying the HWTACACS accounting servers
(Required.)
(Optional.) Specifying a VPN for the scheme
(Optional.) Setting the username format and traffic statistics units
(Optional.) Specifying the source IP address for outgoing HWTACACS packets
(Optional.) Setting HWTACACS timers
(Optional.) Displaying and maintaining HWTACACS
Creating an HWTACACS scheme
Specifying the HWTACACS authentication servers
Specifying the shared keys for secure HWTACACS communication
Command
system-view
snmp-agent trap enable radius
[ accounting-server-down |
authentication-error-threshold |
authentication-server-down |
accounting-server-up |
authentication-server-up ] *
Command
display radius scheme [ radius-scheme-name ]
display radius statistics
reset radius statistics
33
Remarks
N/A
By default, all types of SNMP
notifications are enabled for
RADIUS.