Fixed Throttle Operation Type - Honda GX240RT2 Service And Repair Manual

FIXED THROTTLE OPERATION TYPE

Remove the following parts.
– Air cleaner (page 6-5)
– Muffler (page 14-2)
– Fuel tank (page 6-3)
– Tube clamp (page 6-8) (If equipped)
Installation is in the reverse of removal.
Adjust the maximum speed
GOVERNOR ROD/THROTTLE
RETURN SPRING
REMOVAL/INSTALLATION:
Pull the carburetor assy. (1) out to a
point where the groove (2) of the
throttle arm lines up with the
governor rod (3), and then lift the
governor rod out of the hole of the
throttle arm and unhook the throttle
return spring (4).
(4)
(1)
BOLT (6 x 12 mm) (3)
gx240ut2_gx270ut2_gx340ut2_gx390ut2
(page 7-8).
SERVICE BULLETIN #47 =>
(3)
CONTROL BASE ASSY.
(2)
(If equipped)
GOVERNOR SYSTEM
CONTROL BASE ASSY.
(If equipped)
NUT (6 mm)
OUTER HOLE
GOVERNOR ARM
(If equipped)
GOVERNOR ARM
BOLT
GOVERNOR ARM
SHAFT
GOVERNOR SPRING
INSTALLATION:
Install with the long end
of the spring toward the
control base assy.
Hook the governor spring
to the outer hole of the
governor arm.
GOVERNOR ARM
(If equipped)