Honda GX240RT2 Service And Repair Manual page 100

gx240ut2_gx270ut2_gx340ut2_gx390ut2
Move the governor rod end
the direction shown.
Move the governor spring end
the direction shown.
Holding both sections of the governor arm in alignment
so that the two stops are in contact with one another,
move the governor arm in the direction shown until the
throttle is completely open, and hold it in that position.
Rotate the governor arm shaft (4) as far as it will go in
the same direction it was just moved by the governor
arm, and then tighten the governor arm pinch bolt.
There may be a slight bend in the governor arm when it
is released; this will not affect governor operation.
Move the Auto Throttle solenoid until its actuator arm
just contacts the governor arm, and tighten the two
6 x 12 mm flange bolts.
Install the gas tank (page 6-3).
Turn the Auto Throttle switch to the OFF position, and
start the engine. Allow it to warm to normal operating
temperature.
Move the control lever (5) to run the engine at the
specified maximum speed, and hold the control lever.
Turn the limiting screw to obtain the specified maximum
speed.
MAXIMUM SPEED: 3,850 ± 150 min
Check the Auto Throttle speed, and adjust if necessary
(Refer to page 3-12).
of the governor arm in
of the governor arm in
LIMITING
SCREW
-1
(rpm)
GOVERNOR SYSTEM
PINCH BOLT NUT
GOVERNOR
ARM SHAFT
GOVERNOR
SPRING
GOVERNOR
ROD
CONTACT
AREA
GOVERNOR ARM
STOP
STOP
6 x 12 mm
FLANGE
BOLT (2)
ACTUATOR
ARM