Honda GX240RT2 Service And Repair Manual page 84

Low profile type air cleaner:
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when
handling fuel.
• Keep heat, sparks, and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
Turn the fuel valve lever to the OFF position.
Remove the air cleaner
Set a commercially available tube clip to the fuel tube.
Disconnect the fuel tube from the carburetor.
Remove the drain screw of the carburetor to drain completely.
CARBURETOR INSULATOR
INSTALLATION:
Before installing, clean the passage
thoroughly with compressed air.
Install the carburetor insulator with the
vent groove facing toward the carburetor.
After installing, clamp the high tension
cord to the carburetor insulator.
CARBURETOR
INSULATOR
gx240ut2_gx270ut2_gx340ut2_gx390ut2
(page 6-7).
FUEL TUBE
D8 TUBE CLAMP
INSULATOR
PACKING
HIGH
CARBURETOR PACKING
TENSION
CORD
GOVERNOR ROD/THROTTLE RETURN SPRING
REMOVAL/INSTALLATION:
Pull the carburetor assembly to a point where the
groove of the throttle arm lines up with the
governor rod, and then lift the governor rod out of
the hole of the throttle arm and unhook the throttle
return spring.
Installation is in the reverse order of removal.
GOVERNOR ROD
THROTTLE
RETURN
SPRING
DASH POT CHECK VALVE
To choke diaphragm
To control base stay
(NON-HANDY LEVER B
CARBURETOR
REMOVAL/INSTALLATION:
Remove the fuel tube.
FUEL SYSTEM
TUBE CLAMP
ASSEMBLY:
Install the dash pot into the
tube clamp with the black
end towards the choke
diaphragm.
FUEL TUBE
D8 TUBE CLAMP